Installation On The Steering Column; Adjusting The Microphone Angle; Appendix; Troubleshooting - Pioneer AVH-295BT Manual De Instrucciones

Installation
1 Microphone lead
2 Groove
2 Attach the microphone clip to the sun visor.
1
2
1 Microphone clip
2 Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Install the microphone on the sun visor when it is in the up
position. It cannot recognise the driver's voice if the sun visor is
in the down position.
Installation on the steering
column
1 Detach the microphone base from the micro-
phone clip by sliding the microphone base
while pressing the tab.
1
2
1 Tab
2 Microphone base
2 Mount the microphone on the steering column.
1 Double-sided tape
2 Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Keeping it away from the steering wheel.
Adjusting the microphone
angle

Troubleshooting

1
If you have problems operating this product, refer to this section.
The most common problems are listed below, along with likely
causes and solutions. If a solution to your problem cannot
be found here, contact your dealer or the nearest authorised
2
Pioneer service facility.
Problems with the AV screen
CD or DVD playback is not possible.
 The disc is inserted upside down.
— Insert the disc with the label upward.
 The disc is dirty.
— Clean the disc.
 The disc is cracked or otherwise damaged.
— Insert a normal, round disc.
1
 The files on the disc are in an irregular file format.
— Check the file format.
 The disc format cannot be played back.
— Replace the disc.
 The loaded disc is a type this product cannot play.
— Check what type of disc it is.
The screen is covered by a caution message and the video
2
cannot be shown.
 The handbrake lead is not connected or applied.
— Connect the handbrake lead correctly, and apply the
 The handbrake interlock is activated.
— Park your vehicle in a safe place and apply the handbrake.
The audio or video skips.
 This product is not firmly secured.
— Secure this product firmly.
No sounds are produced. The volume level will not rise.
 Cables are not connected correctly.
— Connect the cables correctly.
 The system is performing still, slow motion, or frame-by-
frame playback with DVD-Video.
— There is no sound during still, slow motion, or frame-by-
 The system is paused or performing, fast reverse or forwards
during the disc playback.
— For the media other than music CD (CD-DA), there is no
The icon  is displayed, and operation is impossible.
 The operation is not compatible with the video configuration.
— This operation is not possible. (For example, the DVD

Appendix

handbrake.
frame playback with DVD-Video.
sound on fast reverse or forwards.
playing does not feature that angle, audio system, subtitle
language, etc.)
37