BEARWARE 303717 Manual página 26

• Second
• Year
• Month / Day format
• Month
• Day
• Time zone - Note: If you set the time zone, for example, to + 01 and the weath-
er station is actuated using the DCF-signal, then the clock displays one hour
later than the DCF-signal.
• Language setting - To set the day on the display. The following codes can be
configured and selected using the "CHANNEL/+" and "MEM/-" buttons: EN
(English), RU (Russian), NL (Dutch), IT (Italian), ES (Spanish), DE (German), FR
(French)
• RC - Enable or disable the DCF signal function.
• DST - Enable or disable automatic switching to daylight saving time.
6.1 Alarm setting
Setting the alarm time
Press the "ALARM" button once briefly to display the alarm time. Then press and
hold the button for about 2 seconds until the alarm time starts to flash. You can
make the desired settings using the "CHANNEL/+" and "MEM/ - " buttons. Confirm
your entry by pressing the "ALARM" button. Then press the "ALARM" button
again to save the alarm setting. The alarm is enabled automatically after setting
the alarm time.
Turning the alarm on / off
Press the "ALARM" button once briefly to display the alarm time. Press the button
again, while the alarm time is being displayed, to turn the alarm on or off. The
alarm is enabled when the bell symbol is shown in the alarm display.
Switching off the alarm
When the alarm is activated at the configured time, the backlight also turns on
automatically. The alarm is active for 2 minutes before it turns off automatically.
Press the "SNOOZE/LIGHT" button to cancel the alarm. If the bell symbol flashes in
the display, this means that the snooze function is enabled and the alarm will go
off again in 5 minutes.
To turn off the alarm, press the "ALARM" button when the alarm goes off.
26
English