Descargar Imprimir esta página

EGO POWER+ LM2150SP-FC Manual De Operaciones página 53

Cortadora inalámbrica de iones de litio de 56 voltios
Ocultar thumbs Ver también para POWER+ LM2150SP-FC:

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
The mower
does not
mulch properly
The mower
stops while
mowing
There is
excessive
vibration
The handle-
locking clamps
cannot be
closed in
position
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2130SP/LM2130SP-FC/LM2130/LM2130-FC/LM2150SP/LM2150SP-FC
CAUSE
Wet grass clippings are sticking
to the underside of the deck.
The mower is set to cut too much
grass at once.
The battery pack is depleted.
Mower is in overload condition.
Mower deck is clogged with
grass and debris.
The battery pack or mower
circuitry is too hot (The power
indicator on the mower emits an
orange light for 10 seconds).
The side rail is retracted a little
by the pushing force applying on
the handle.
The cutting blade is loose.
The cutting blade set is
unbalanced.
The cutting blade is bent.
The motor shaft is bent.
The mower is set to cut too much
grass at once.
The side rails are not fully
extended.
SOLUTION
Wait until the grass dries before
mowing.
Raise the deck to a higher
cutting-height setting.
Charge the battery pack.
Raise the cutting height or slow
down the mowing.
Unclog the mower deck. Raise
the cutting height and/or cut a
narrower swath.
Allow the battery pack or mower
to cool until the temperature
drops below 152°F (67°C).
Unlock the clamps. Fully extend
the side rails and lock the
clamps again.
Tighten the outer nut.
Balance the blade set following
the"SHARPENING THE BLADE".
Replace the blade.
Contact the service center.
Raise the deck to a higher
cutting-height setting.
Fully extend the side rails, then
lock the clamps.
53

Publicidad

loading