Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
10. To avoid an overloaded circuit, do not operate another high voltage
appliance in the same electric circuit.
11. The iron must be used and rested on a stable surface. When placing the iron
on its Heel Rest, ensure that the surface on which the Heel Rest is placed is
stable.
12. The iron is not to be used if it has been dropped, if there are visible signs of
damage or if it is leaking.
13. The iron is for household use only.
14. To protect against burns or injury to persons, do not direct steam toward
the body when ironing or self-cleaning.
15. Always turn the iron OFF before plugging or unplugging the iron from the
electrical outlet. Never pull on the cord to disconnect the iron from the
electrical outlet; instead, grasp the plug and pull on the plug to disconnect
the iron.
16. Do not let the cord touch hot surfaces. Let the iron cool completely before
putting the iron away. Coil the cord loosely around the iron when storing.
17. Do not operate the iron with a damaged cord or in the event the iron has
been dropped or damaged. To avoid the risk of electric shock, do not
disassemble the iron. Take it to a qualified servicemen for examination and
repair. Incorrect assembly might result in a risk of electric shock when the
iron is used after reassembly.
18. Burns can occur from touching hot metal parts, hot water, or steam. Use
caution when you turn upside down - there might be hot water in the
reservoir.
SAVE THESE INSTRUCTIONS
NOTE: · Some parts of the iron have been slightly greased and as a result, the iron may smoke
slightly when switched on for the first time. It will not happen again after a few uses.
· Before using for the first time remove any protective films or stickers from the soleplate
and the cabinet. Clean the soleplate with a soft cloth.
· When using the iron for the first time, test it on an old piece of fabric to ensure that the
soleplate and water tank are completely clean.
SAFETY PROTECTIVE CUT-OUT
In the unlikely event of the thermostat failing, the protection cut-out will operate to
prevent the iron from overheating. If this occurs contact customer satisfaction center.
ELECTRICAL REQUIREMENTS
This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit into a polarized outlet only one way.
If the plug does not fit into the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to modify the plug in any way.
NOTE: This appliance requires a minimum of 1600 watts and it should be the only appliance
operating on the circuit.
Page 4
HOUSEHOLD USE ONLY
Publicidad
