Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
AUTO SHUTOFF
An electronic safety device will automatically switch the heating element off if the
iron has not been moved for more than 30 seconds in a horizontal position (on its
soleplate or side). If in a vertical position, this will happen after 8 minutes. To indicate
that the heating element has been switched off, the control panel will display PAUSE.
When the iron is picked up again, the indicator light will turn on to indicate that the
iron is heating up again. Wait for the indicator light to turn off and the panel display
will indicate the selected fabric. Then, the iron is ready for use.
SELF CLEANING:
The iron needs to be self-cleaned every 10-15 days:
1) Push the Steam Control Slider to " " position.
2) Push the Temperature Control Button to select the LINEN
setting. Wait until LINEN stops blinking in the control panel
display and the temperature indicator light turns off to indicate
that the iron has reached the highest temperature.
3) Unplug the power cord and hold over a sink immediately.
4) Hold the Self-Cleaning Button and water will drip from the steam spray holes in
the soleplate.
5) After the water tank is empty and no more water drips out, put the iron on the
shelf till it is dry.
HOW TO CLEAN AND STORE
After using, lift the iron with the filling hole downwards to empty the remaining water
from the Water Tank.
Insert the plug into standard wall socket and set the Temperature to the LINEN
setting for 1-2 minutes to evaporate the remaining water. Then, unplug the iron and
let it cool down before storing. The soleplate of the iron can be cleaned using a damp
cloth once the iron is completely cool.
Page 8
Publicidad
