Beurer MG 260 Manual De Instrucciones página 13

6. Start-up
• Position the seat cover upright on a suitable seat with a sitting area and backrest (chair, sofa or
similar). Make sure that the seat has a sufficiently high backrest.
• Use the flexible fastening straps and hook-and-loop fasteners to secure the Shiatsu seat cover.
• Connect the device to the mains by plugging the plug into the socket.
7. Operation
Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the
contact pressure if you find it is painful or unpleasant.
• Do not force or jam any part of your body, in particular your fingers, between the rotating massage elements
or their holders in the unit.
• Sit comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• Switch on the massager with the
The LEDs signal the massage functions which are currently selected.
• The automatic switch-off function is activated with selection of the massage region and is preset to 15
minutes. You can set the automatic switch-off function to 5, 10 or 15 minutes by pressing the timer but-
ton. Please note that changing the timer setting makes the timer start to count again from the beginning.
To avoid overheating the device, select the maximum massage duration at the beginning of the massage
and do not change it again during the massage.
You can specify the settings as follows:
1. Demo run
Press the demo button to begin a quick 5-minute run-through of the functions contained in the device.
The manual controller indicates which function is being displayed by flashing the respective LED. The
device switches off automatically once the demo run has finished.
2. Neck massage
Press the neck button to start the neck massage. Press neck
(clockwise rotation) to change the direction of the massage.
3. Shiatsu back massage
Press the shiatsu button. Select the desired massage region with full back, upper back, lower back.
You can choose a spot massage i.e. a Shiatsu massage without vertical movement by pressing the spot
button. You can change the position of the spot massage by holding down one of the arrows next to the
spot button until the desired position is reached.
Massage intensity
When using the Shiatsu Massage, two different massage speeds are available, which can be selected
using the speed button. If you have the rolling massage activated, first press the shiatsu button in order
to change to Shiatsu Massage and then set the desired massage speed.
4. Rolling massage
Press the rolling button. Select the desired massage region with full back, upper back, lower back.
When the massage type (Shiatsu or rolling massage) is changed, the preselected region (full, upper, lower
back) is retained. Note that the massage region must be selected again when switching from localised
Shiatsu massage to rolling massage.
5. Heating function
Press the heat button to switch on the heating function of the massage heads. The blue lights in the mas-
sage heads change colour to red.
• Do not use the massage device for longer than 15 minutes and then allow it to cool. Using the device
for longer can over-stimulate the muscles and cause tension instead of relaxation. The massage can be
finished at any time by pressing the
button.
button. Please note that on switching off, the massage heads first
13
(anti-clockwise rotation) or neck