Beurer MG 260 Manual De Instrucciones página 14

return to the starting position at the lumbar region. This is indicated by the LED flashing. Once this position
is reached, the device switches off.
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait
until it has returned to the initial position.
Note
• The device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.
8. Care and storage
Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• The removable covers are machine-washable at 40 °C. Please note the symbols for care and
cleaning on the label sewn into the cover.
The PU cover at the back is secured with a hook-and-loop fastener under the material bearing the
beurer logo and can be removed from there.
The cover for the neck area can be removed using the zip at the side of the control knob for the
height-adjustable neck massage.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
9. In the event of problems
Problem
Massage heads
rotating at
reduced speed.
Massage heads
only rotate in the
upper or lower
region.
Massage heads
not moving.
Cause
The load on the massage
heads is too great.
The massage has been
activated for the limited
region.
Appliance not connected to
the power supply.
Device not switched on.
Overheating protection
tripped, device is damaged.
Remedy
Reduce the contact pressure on the head.
Press the full back, upper back, lower back
buttons to change the massage region.
Press the neck button to activate the neck
massage.
Connect the plug to the mains supply and
switch on the appliance.
Switch the device on with
Select the massage region.
Contact your authorized dealer or the service
address.
14
.