GRAPHITE 58G045 Manual Del Usuario página 11

* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Blade
2. Hex key
3. Dust extraction stub pipe
BLADE INSTALLATION
Disconnect the power tool from power supply.
● Use the hex key to loosen screws that fix the blade shaft (
● Slide blade into clamp, push to the limit
● Blade's teeth should point forward.
● Tighten the screws with the hex key (
Ensure the blade is properly fitted in the guide roller (10) (fig. A).
Blade removal is similar to installation, only the sequence of actions is reversed.
Use blades shown on fig. F, suitable for clamp mechanism.
DUST EXTRACTION
To improve dust extraction from processed surface the jigsaw is equipped with own dust blow-off system, which cleans the
surface being cut. Additionally, there is possibility to connect vacuum cleaner to dust extraction stub pipe (4). Dust blow-off
and extraction system is more efficient when the jigsaw guard is lowered.
SWITCHING ON / SWITCHING OFF
Before connecting the jigsaw to a power supply always check that power supply voltage matches rated voltage
on the rating plate fixed on the power tool.
Switching on – press the switch button (2) and hold in this position (fig. B).
Switching off – release pressure on the switch button (2).
Locking the switch (continuous operation)
Switching on:
● Press the switch button (
● Press the switch lock button (
● Release pressure on the switch (
Switching off:
● Press and release the switch (
- 1 pce
- 1 pce
- 1 pce
PREPARATION FOR OPERATION
fig. A).
OPERATION / SETTINGS
2) and hold in this position.
3) (fig. B).
2).
2).
fig. A).
11