Create UPWIND SAIL Manual Del Usuario página 9

1. Hang the motor housing on the mounting bracket. Rotate the fan so that the notch on the
ball engages the ridge in the mounting bracket.
2. Place the remote control receiver in the slot on the mounting bracket as shown in the figure.
• Check and confirm that all connections are proper and secure. When all the electrical con-
nections are done, store all wires neatly.
• Do not attempt to control this fan from any wall or remote control that is not approved by the
manufacturer for use with this fan. DO NOT use a solid state controller. The use of an unap-
proved wall or remote control will void the warranty.
• Do not connect the ceiling fan to a dimmer switch or a regulator.
• Mark the correct position of the holes and fix the ceiling bracket using the screws with
metal anchor or screws and washers suitable for the type of ceiling chosen.
• Check the correct installation of the bracket before hanging the fan. This plate must
support the full weight of the fan.
Fixing the mounting bracket
The outlet box and joist must be securely mounted and capable of reliably supporting at
least the weight of the fan.
Wooden ceiling
Securely attach the mounting bracket
with wood screws and washers to the
ceiling joints.
Don't fix the mounting bracket directly on ceilings thinner than 10mm to avoid the risk of the
wood screw becoming loose.
Notch
Ridge
INSTALLATION INSTRUCTIONS
Receiver
Concrete ceiling
Bore holes with an 8mm drill, according
to the length of the expansion screws. Af-
ter that, fix the mounting bracket on the
ceiling with the expansion screws.
E NGLI SH
9