Create UPWIND SAIL Manual Del Usuario página 13

Installing the decorative cover
1
After installing the blades, align the decorative cover with the motor axis and screw it clock-
wisely until it is securely fixed.
Check the installation
• Check the correct operation of the ceiling fan, checking that no strange movement or
misalignment is observed in any part of the fan.
• In the event that some kind of hum / vibration can be seen, you can proceed to adjust the
blades with the shooting kit.
• This kit has self-adhesive weights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip to a
different blade or use the adhesive weights.
1. Speed control
2. ** Light control button
3. Off button
4. On indicator light
5. Timer
6. Batteries
** Function only available when
having the LED plate installed.
Warnings
1. Use this product under the correct tension. Too low a voltage will result in a failed operation.
2. Remove the batteries from the remote if you are not going to use it for a long time.
Note: For safety reasons and to ensure optimum performance, connect the ground wire correctly.
3. When installing the fan, make sure that nothing is pressing on the receiver antenna or
other cables to prevent a short circuit.
CEILING FAN WITHOUT LED LIGHT
2
REMOTE CONTROL
1
2
3
4
5
3
6
E NGLI SH
13