Lincoln Electric LINC FEED 24M PRO Manual De Instrucciones página 11

WEEE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE)
and its implementation in accordance with national law, electrical equipment that has reached the end of its
life must be collected separately and returned to an environmentally compatible recycling facility. As the
owner of the equipment, you should get information on approved collection systems from our local
representative.
By applying this European Directive you will protect the environment and human health!
Spare Parts
Part List reading instructions
• Do not use this part list for a machine if its code number is not listed. Contact the Lincoln Electric Service
Department for any code number not listed.
•
Use the illustration of assembly page and the table below to determine where the part is located for your particular
code machine.
•
Use only the parts marked "X" in the column under the heading number called for in the assembly page (# indicate
a change in this printing).
First, read the Part List reading instructions above, then refer to the "Spare Part" manual supplied with the machine, that
contains a picture-descriptive part number cross-reference.
Electrical Schematic
Refer to the "Spare Part" manual supplied with the machine.
Accessories
K10347-PG-xxM Source/wire feeder cable (gas). Available in 5, 10 or 15m.
K10347-PGW-xxM Source/wire feeder cable (gas and water). Available in 5, 10 or 15m.
K10158 Plastic adaptor for 15-kg coils.
K14032-1 Heavy duty undercarriage wheels kit.
K14073-1 AV Meter Kit (LF 22M only).
KP14016-0.8
KP14016-1.0
KP14016-1.2
KP14016-1.6R
KP14016-1.2A
KP14017-0.8
KP14017-1.0
KP14017-1.2
KP14017-1.6
KP14017-1.6R
KP14017-2.4R
KP14017-1.2A
KP14017-1.6A
English
LF 22M: Drive rolls and guide tubes 2 driven rolls
Solid wires:
0,6-0,8mm
0,8-1,0mm
1,0-1,2mm
Cored wires:
1.2-1.6mm
Aluminum wires:
1,0-1,2mm
LF 24M, 24M PRO: Drive rolls and guide tubes 4 driven rolls
Solid wires:
0,6-0,8mm
0,8-1,0mm
1,0-1,2mm
1,2-1,6mm
Cored wires:
1.2-1.6mm
1.6-2.4mm
Aluminum wires:
1,0-1,2mm
1,2-1,6mm
8
07/06
12/05
English