AEG KSK782280M Manual De Instrucciones página 42

5.1 Initial Cleaning
Step 1
Remove all accessories and remov‐
able shelf supports from the appli‐
ance.
5.2 First connection
The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.
5.3 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper into
water for about 1 sec. Do
not put the test paper un‐
der running water.
The colours of the test paper continue to change. Do not check water hardness later than 1 min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Water hardness
Level dH
1 0 - 7
2 8 - 14
3 15 - 21
4 ≥22
42 ENGLISH
Clean the appliance and the acces‐
sories only with a microfibre cloth,
warm water and a mild detergent.
Step 2
Shake the test paper to re‐
move the excess of water.
Test paper
Step 2
movable shelf supports in the appli‐
Step 3
After 1 min, check water
hardness with the table
below.
Calcium depos‐ Calcium de‐
it (mmol/l) posit (mg/l)
0 - 1.3
1.4 - 2.5
2.6 - 3.8
≥ 3.9
Step 3
Place the accessories and the re‐
ance.
Step 4
Set the water hardness lev‐
el: Menu / Settings / Setup /
Water hardness.
Water classifi‐
cation
0 - 50
51 - 100 moderately hard
101 - 150 hard
≥151 very hard
soft