Fisher Scientific Bead Mill 4 Homogenizer Manual Del Usuario página 8

1.
Turn unit off and unplug power cord.
1.
Turn unit off and unplug power cord.
4.
Secure the new neck gasket using
the restriction tie with the clamp
positioned toward the bottom of
the instrument.
Tighten central screw.
Changing the Tube Holder
2.
Use the supplied 3 mm allen
wrench to loosen tube carriage
holder screw
Changing the Neck Gasket
2.
Use the supplied 3 mm allen
wrench to loosen the central screw
and remove restriction tie and old
neck gasket.
5.
Use the supplied 3 mm allen
wrench to tighten the central screw
and secure the tube carriage.
3.
Use the supplied 3 mm allen
wrench to tighten tube carriage
holder screw
3.
Slide the new neck gasket onto the
pivot shaft and housing