Salicru EQUINOX SLC EM Lite Manual De Usuario página 79

Access the on-board panel via the preset IP: 192.168.6.2 or
192.168.7.2, depending on the IP assigned to the PC. See section
"8.3. On-board panel." to continue the SLC ENERGY MANAGER
network configuration guide.
8.2. DEFAULT CONFIGURATION.
The SLC ENERGY MANAGER device is configured by default with
the necessary parameters to successfully use the on-board panel
and all of its functionalities. These are:
Configuration of Modbus protocol parameters.
•
Configuration of NTP servers.
•
Configuration of calibration parameters.
•
IP address acquired by DHCP.
•
Active RTC.
•
It is possible to modify some of these parameters at any time
from the On-board Panel. For more information, see section
"8.3. On-board panel.".
Please note that modifying some of these parameters may
cause the device to behave in an undesired way. Do not
modify them if you are not sure.
8.3. ON-BOARD PANEL.
This service allows you to monitor the status of the unit remotely
and in real time. It allows network configuration of the device and
remote management of some functionalities.
8.3.1. Access to the On-board Panel.
Access to the panel is via "https://" and therefore do not forget to
write it in front of the preset or subsequently assigned IP address.
Otherwise, the connection will not be made correctly.
The On-board Panel uses a self-signed SSL certificate and
the browser identifies the path as unsecured. To remove
this warning, see Annex II "Import Certificate", depending on the
browser used.
8.3.1.1. WiFi Access Point.
Find the device's WiFi Access Point.
1.
The list of WiFi networks will show the Access Point with the
serial number of the device.
Proceed to connect to the Access Point; the password is the
same as the serial number of the device.
USER MANUAL
2
3
Connect to the Access Point via browser.
2.
Access the browser and enter IP address 192.168.1.50.
1
79
SLC ENERGY MANAGER ENERGY METER