Salicru EQUINOX SLC EM Lite Manual De Usuario página 80

Depending on the browser you are using, you will see the
message that you are entering an unsecured URL, accept
everything and enter.
Login screen.
3.
Once you access the On-board Panel, the first screen you will
see is the following:
To log in, enter the appropriate credentials depending on the
user accessing the panel.
Username
Password
Permission
Navigation menu.
4.
The navigation menu (view as Engineer) is located on the left
side of the screen:
The content of each screen is detailed below:
Information: Screen showing the current configuration.
•
Network configuration: Screen for configuring the network
•
via WiFi or Ethernet.
Proxy: Screen for configuring a proxy server.
•
NTP: Screen for modifying the NTP servers.
•
80
User Installer
guest engineer
SLCg13st SLC3ng1n
Network configuration
and NTP servers.
Network configuration Commissioning of the
and NTP servers installation.
Modify Zero Injection
Control parameters.
The installer user incorporates a new screen for man-
aging the necessary Energy Manager parameters at
the time of installation.
8.3.2. Information.
The Information page shows a summary of the current configura-
tion of the unit.
The first time the device is connected, the information displayed
on the screen corresponds to the default configuration. If no data is
displayed, this means that no configuration has been set up so far.
If the information is not displayed correctly, exit the panel
using the logout option and log in again or clear the browser
cache and press CTRL + F5.
8.3.3. Network configuration.
Press Network Settings to enter the network settings. The net-
work can be configured via the Ethernet port or by using a WiFi
network.
Both with the WiFi network configuration and the IP
configuration via Ethernet cabling, a connectivity test can
be carried out to verify that the device has Internet access and has
been configured correctly.
100.0.0.1
172.26.1.1
255.255.255.0
172.26.0.250
172.26.0.251
SALICRU