Hansgrohe E 04355 0 Serie Instrucciones De Montaje página 16

3
1
Ø
16

3


English
Lift the cartridge out (1).
Turn the cartridge 180°, so that the "hot side"
marking is on the right ().
Install the cartridge (3)
Install the nut (4).
Continue the installation.
4
Adjust the Rotational Limit Stop
Adjust the rotational limit stop if:
• The maximum output temperature is
greater than 10°F or that permitted by
local plumbing code
• The temperature of the incoming hot or
cold water supply changes seasonally, or
if changes are made to the water heater.
Turn the rotational limit stop, clockwise to
make the water cooler, counter-clockwise to
make it warmer.
Depending on local conditions, each notch
represents a change in temperature of 4°F
- 16°F.
Continue the installation.