Garland SCAR 501 E Instrucciones De Montaje página 21

Do not overstretch the cable. Do not use the cable
to transport the machine, lift the machine and to
unplug the machine. Maintain the cable far away
from heat sources, oil, sharp edges or other moving
parts. Damaged or tangled cables increase the risk of
electric shock.
Never use this machine if the cable or the plug are
damaged. Before connecting the machine check
that the cable and the plug are not damaged. If you
discover that either of these elements are damaged,
take your machine to your nearest after sales
dealer. Should the cable be damaged, unplug the
machine inmediately. Damaged or tangled cables
increase the risk of electric shock.
The substitution of the plug or cable should be
done by an approved and homologated after sales
service. We recommend that this machine should be
connected to residual differential whose current is
lower or equal to 30mA.
Never use a connecting base that is damaged or that
does not comply with current normatives or with the
requisites established for this machine in this manual.
When using a cable extension, make sure that its
minimum section is 1.5mm2 and no longer than 25
metres, always unrolled and adequate for outdoor use.
The use of the cable extension adequate for outdoor
use, reduces the risk of electric shock.
Place the cable extension in such a way that it will not
get caught in branches or other obstacles and in such
a way that it is not in the working area. The cable and
any extensions must always be behind the machine
and the end user.
Always hold the cable extension in the hook provided
on the machine.
Connect this machine to alternate current 230v/50Hz.
Do not expose this machine to rain and wet
and humid conditions. If water enters the
machine there will be a higher risk of electrc shock.
Maintain the cable well clear of the cutting
element at all times.
Do not use this machine if the ¨open¨ and ¨closed¨
switch does not work. Any electric machine that
cannot be controlled by the electric switch is
dangerous and must be repaired.
Always disconnect the machine before carrying
out any work on the machine. Only manipulate the
machine when disconnected.
2.5. USAGE AND CARE OF THIS MACHINE
Only scarify areas with grass. Do not use this
machine for other uses. For example: do not use
the machine to weed, sweep or to sand any type
of surface. The use of this machine for other uses
for which it has not been designed could cause
dangerous situations.
Use this machine, accessories and all its parts
according to the instruction manual and taking into
account working conditions and working area. The use
of this machine for jobs different to those specified in
the instruction manual can cause dangerous situations.
The manufacturer will not be in any case held
responsible for damages caused through an
inadequate or incorrect usage of this machine.
Do not overload the machine. Use the machine
for the work it has been designed for. The correct
machine usage will allow you to work better and in a
more secure way.
21/100
English