Descargar Imprimir esta página

Pioneer AVH-Z2250BT Manual De Instrucciones página 48

Publicidad

Idiomas disponibles

Idiomas disponibles

the voltage changes when the gear shift
is in the REVERSE (R) position. This
connection enables the unit to sense
whether the car is moving forwards or
backwards.
Yellow/black
If you use an equipment with Mute
function, wire this lead to the Audio
Mute lead on that equipment. If not,
keep the Audio Mute lead free of any
connections.
Blue/white
Connect to system control terminal of
the power amp (max. 300 mA 12 V DC).
Light green
Used to detect the ON/OFF status of the
handbrake. This lead must be
connected to the power supply side of
the handbrake switch.
Power supply side
Handbrake switch
Earth side
Speaker leads
Perform these connections when using a
subwoofer without the optional amplifier.
48
En
To power supply
Power cord
Left
Right
Front speaker (STD) or high range
speaker (NW)
Rear speaker (STD) or middle range
speaker (NW)
White
White/black
Grey
Grey/black
Green
Green/black
Violet
Violet/black
Subwoofer (4 Ω)
When using a subwoofer of 2 Ω, be sure
to connect the subwoofer to the violet
and violet/black leads of this unit. Do
not connect anything to the green and
green/black leads.
Not used.
Subwoofer (4 Ω) × 2
NOTES
• When a subwoofer is connected to this
product instead of a rear speaker, change
the rear output setting in the initial
setting. The subwoofer output of this
product is monaural.
For details, refer to [Rear Speaker Output]
(page 41).
• With a two-speaker system, do not
connect anything to the speaker leads
that are not connected to speakers.
Power amp (sold
separately)
Without internal amp
Important
The speaker leads are not used when this
connection is in use.
With internal amp
Important
Front speaker and Rear speaker signals
(STD) or middle range speaker and high
range speaker signals (NW) are output
from the speaker leads when this
connection is in use.
System remote control
Connect to Blue/white cable.
Power amp (sold separately)
Connect with RCA cable (sold
separately)
To Rear output (STD)
To middle range output (NW)
Rear speaker (STD)
Middle range speaker (NW)
To Front output (STD)
To high range output (NW)
Front speaker (STD)
High range speaker (NW)
To subwoofer output (STD)
To low range output (NW)
Subwoofer (STD)
Low range speaker (NW)
NOTE
Select the appropriate speaker mode
between standard mode (STD) and
network mode (NW). For details, refer to
Starting up the unit (page 7).
iPod/iPhone and
smartphone
NOTES
• For details on how to connect an external
device using a separately sold cable, refer
to the manual for the cable.
• For details concerning the connection
and operations of iPhone or smartphone,
refer to the chapter of each source or
application.

Publicidad

loading