Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3
Fasten the TOP MOLDING (M20) to the TOP (E). Use three
å
BLACK 1-1/8" PAN HEAD SCREWS (9S).
NOTE: You should start each SCREW a few turns before completely
å
tightening them. Do not overtighten.
Push three HOLE PLUGS (14P) into the holes in the TOP MOLDING.
å
Slide the END MOLDINGS (G) onto the notched edges of the
å
ENDS (A and B) until they are against the TOP MOLDING.
*U.S. Patent No. 5,499,886
å
G
www.sauder.com/services
Notched edge
B
G
420178
BLACK 1-1/8" PAN HEAD SCREW
(3 used in this step)
Do not overtighten
the SCREWS (9S).
M20
E
A
9S
14P
Page 7
Publicidad
