Publicidad
Idiomas disponibles
Idiomas disponibles
the magnetic holder
z Charging the battery
RISK OF ELECTRIC SHOCK!
The cordless magnetic lamp
should only be recharged in dry
indoor areas using an SELV mains adaptor.
Before using the cordless magnetic lamp
for the first time, please fully charge the
battery. To do so, use only the USB charging
cable supplied
(see Fig. D). This lamp
11
must not be operated while being charged.
Plug the USB charging cable supplied
„ „
into the micro-USB socket
(see Fig. F).
To charge the lamp, connect the USB
„ „
charging cable
11
(5 V
, max. 0.48 A).
Plug the USB mains adaptor into a power
„ „
outlet socket.
The charging time is approx. 3-4 hours. The
charge indicator
3
cordless magnetic lamp is fully charged. As
soon as the cordless magnetic lamp
fully charged, the charge indicator
green. You can then unplug the USB mains
adaptor from the power outlet socket and
disconnect the USB charging cable
the cordless magnetic lamp
z Switching the cordless
magnetic lamp ON/OFF/
Setting motion sensor
function
The cordless magnetic lamp can be
„ „
switched on or off using the ON/OFF/
AUTO switch
�
5
The cordless magnetic lamp has two
„ „
functions: permanently on and 30-second
timer function when the motion sensor
triggered. For the permanently on function,
slide the ON/OFF/AUTO switch
side of the lamp to the ON position (see
Fig. A). Maximum illumination time when
44
GB/IE/NI/CY/MT
�
7
1
11
on the lamp
4
to a USB mains adaptor
remains red until the
is
1
shows
3
from
11
�
1
6
on the
5
fully charged: approx. 3 hours.
To activate the motion sensor
only operates in the dark (approx. 16 lux
or below), set the ON/OFF/AUTO switch
to the position AUTO. The cordless
5
magnetic lamp will then switch on
automatically for 30 seconds whenever
movement is detected within the motion
sensor's detection range of 3-4 metres. The
1
lamp will switch off again automatically
after that time. To completely switch off the
cordless magnetic lamp, set the ON/OFF/
AUTO switch
position (see Fig. A).
z Cleaning and storage
RISK OF ELECTRIC SHOCK!
There is a risk of electric shock from
parts that carry electric current.
Unplug the USB mains adapter from the
power outlet socket before attempting to
clean the lamp.
RISK OF DAMAGE!
Cleaning the cordless magnetic
lamp and accessories incorrectly
could damage them.
Before cleaning the cordless magnetic
„ „
lamp, always switch it off and remove the
USB charging cable.
Do not use corrosive cleaning agents,
„ „
brushes with metal or nylon bristles or not
sharp or metallic cleaning implements such
as knives, hard spatulas or similar items.
They may damage the surfaces.
Never clean the cordless magnetic lamps
„ „
or accessories under running water.
Wipe down the cordless magnetic lamps
„ „
and accessories with a slightly moistened
cloth.
Wipe the cordless magnetic lamps and
„ „
is
accessories completely dry.
When the cordless magnetic lamp is not in
„ „
use, store it in a dry place and make sure it
is switched off.
, which
6
to the centre, OFF,
5
Publicidad
