Caso Germany VC200 Manual Del Usuario página 49

16 Troubleshooting
This chapter provides you with important notices with regard to operating
the device. Observe the following notices to avoid dangers and damages:
16.1 Safety notices
► Only qualified electricians, who have been trained by the manufacturer,
may carry out any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the
user and damages to the device.
16.2 Cause and Action
In the event of a fault, an error code will appear in the display; it describes
the cause of the fault.
Error
Vacuum unit is not
functioning
The first weld on the cut
off piece of the roll is not
being carried out.
A complete vacuum is
not being created in the
bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
caso Vakuumierer VC200
Attention
Possible cause
Power plug is not plugged in
Defective power cable or plug
Defective electrical socket
Roll is not positioned correctly
The open end of the bag is not
completely inside the vacuum
chamber
The bag is defective
There is dirt on the welding and the
normal seals
The welding bar is overheating so
that the bag melts
The bag is defective
Rectification
Plug in mains plug!
Send device to Customer
Service
Select another electrical socket
Follow the steps in the chapter
"Vacuum packaging in a bag
originating on the roll"
Position the bag correctly
Select another bag
Clean the seals and retry
correctly once they are dry
Open the cover on the unit and
let it cool down for a few
minutes
Select another bag; wrap paper
serviettes around any sharp
edges on the content
49