Aprimatic APRIBOX 700 Manual De Instrucciones página 23

PROGRAMMING THE RADIO REMOTE CONTROLS
PROGRAMMING THE CHANNEL FOR ACTIVATING THE AUTOMATION
Check that the control units is not set to operate with the dead man's switch (DIPs 2 and 3 must not both be OFF).
!
Power up the control
unit and put DIP 4
on OFF
At the end of the
operation, press button
P2/RAD again to exit
the procedure.
(green LED goes off)
PROGRAMMING THE CHANNEL FOR ACTIVATING THE COURTESY LIGHT
Using this procedure the installer can switch on the courtesy light independently with a radio remote control key (different from
the one selected in the previous paragraph for opening and door).
Power up the control
unit and put Dip 4
on ON
At the end of the
operation, press button
P2/RAD again to exit
the procedure.
(green LED goes off)
The programming procedures are exited automatically in any case 10 seconds after the last transmission.
!
DELETING ALL THE CODES
Using this procedure the installer can delete all the previously programmed radio remote controls from the memory.
Hold down button P2/RAD per 3
secondi for 3 seconds (the green LED
begins to flash rapidly)
Press button P2/RAD
for 2 secondi
(the green
LED comes on)
Memorise all the
transmitters making a
transmission with the
desired key.
Press button P2/RAD
for 2 secondi
(the green
LED comes on)
Memorise all the
transmitters making a
transmission with the
desired key.
Make a transmission
pressing the desired key
on the transmitter.
During entry, the green
LED flashes and then
remains steady on once
the code is memorised.
Make a transmission
pressing the desired
key on the
transmitter.
During entry, the green
LED flashes and then
remains steady on once
the code is stored.
Press button P2/RAD again within
6 seconds to confirm the deletion
(deletion is confirmed by the flashing
becoming faster)
GB
22