Publicidad
Idiomas disponibles
Idiomas disponibles
If you have connected the soundbar to a Bluetooth device that supports
the ADP and AVRCP profiles (Audio Video Remote Control), the sound-
bar is used as an output medium and the audio signals are only output
through the soundbar.
In case of an incoming call, music playback is interrupted and only con-
tinues when the call has ended.
. Switching on the soundbar
Switch the soundbar on either by pressing the
or on the soundbar.
Switch on your audio device.
Select a medium volume and start playback.
If a TV or an external device is connected via the AUX or HDMI sockets,
the soundbar will switch on automatically a few seconds after the televi-
sion or the external device is switched on.
If the TV or the external device is disconnected or switched off, the
soundbar will switch off automatically after approximately minutes.
If the volume of the television or external devices is too low, the sound-
bar will also switch off after approximately minutes (but only if the
devices are connected via AUX).
. Selecting the audio source
Press the SOURCE button on the soundbar or press the OPTICAL, AUX,
ARC button on the remote control to select the audio source you want.
Colour LED operating displays indicate the selected operating mode:
Status
lights up red
flashes blue
lights up blue
lights up green
lights up orange
lights up white
Operating mode
Standby mode
Bluetooth® search mode
Bluetooth operating mode
AUX operating mode
Operating Mode OPTICAL
Operating Mode HDMI ARC
button on the remote control
or HDMI
Publicidad
