Best PK2230 Manual De Instrucciones página 9

12. CONNECT WIRING (ALL MODELS)
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power from being switched on accidentally.
Position the power pack below its custom hood.
INTERNAL BLOWERS: Insert the house wiring cable through the wire clamp
previously installed in step 8. Tighten the wire clamp to
secure the cable. Connect cable into electrical compartment
using included wire connectors. Connect BLACK to BLACK,
WHITE to WHITE and GREEN or bare wire under green
ground screw. DO NOT FORGET TO CONNECT THE
GROUND. Reinstall electrical compartment cover.
IN-LINE OR EXTERNAL BLOWERS: See instructions included with blower.
13. CONNECT DUCTING (ALL MODELS)
A. When there is access to the top of the hood, connect ductwork and seal connections with metal foil duct tape after Step 14 Install power
pack.
B. When there is no access to the top of the hood, carefully pull down the metal duct through the custom hood base hole. Slide this duct
over the adapter (internal blower) or over the flange of the rough-in plate (in-line or external blower). Make sure the adapter/damper
assembly enters the ducting. Seal joint with metal foil duct tape.
14. INSTALL POWER PACK
Take care not to kink ducting when installing the power pack.
TIP: Two of the six no. 8-18 x 1¼" provided chrome plated screws can be
used to temporarely support the power pack during installation. Place
the power pack inside the custom hood and insert both side screws.
The power pack can now be secured to the custom hood without having
to hold it in place.
Using provided no. 8-18 x 1¼" chrome plated screws, secure the power pack
inside the custom hood. Install 1 screw at each corner. (See figure at right for
mounting screw locations.)
WARNING
!
CAUTION
HD0497
HD0498
9
HE0157
S
UPPORT SCREW LOCATIONS
M
OUNTING SCREW LOCATIONS