Descargar Imprimir esta página

UFESA STEAM ULTRA Manual De Instrucciones página 18

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 3
Fillin the Water Tank
Remove the water tank from the station and fill it throu h the water inlet cover. Do NOT fill over the MAX
level indicator.
Make sure when placin it back to the station that it fits correctly.
OPERATING INSTRUCTIONS
NB: If it is the first time you have steam-ironed or if the product has not been used for some time, turn
the temperature control to a steam ironin position and press the steam button continuously until
steam comes out. This process can take a few minutes.
Place the Steam Station on a firm level table, bench or ironin board.
Plu the unit into a power outlet and switch on at the power point.
Adjust the temperature dial in terms of choose the kind of fabrics that you want to iron.
Note: If you want to use the steam ironin , we su est you to adjust the temperature dial on MAX.
When the iron operatin li ht indicator oes out the device will be ready for use.
Note: Durin the whole operatin time, the iron operatin li ht indicator will o on and o in erratic inter-
vals, this is normal.
To make the steam jet come out, select the steam position with the steam selector and press the steam
tri er, and if you want to stop the steam release the steam tri er, in a few seconds steam will stop.
Select the steam settin by pressin and holdin the steam button. The steam settin can be switched
o at any time by releasin the steam button. Push the steam locker with continues steamer without
pressin the steam button.
Ironin Tips
• Start with the fabrics to be ironed at a low temperature and finish with those that need hi her temper-
atures.
• For mixed fibre fabric, set the ironin temperature to a lower settin .
• For woollen arments, press the steam tri er repeatedly over the arment without physically touchin
it with the iron.
• For thicker fabrics, raise the iron temperature at MAX position.
Ironin Guide Chart
Below is a uide on the temperature settin required for di erent types of fabric, alon with the recom-
mended iron method.
Markin
. (1 dot)
18
All manuals and user guides at all-guidesbox.com
Material, for example
Acetate, elastane, polyamide, polypropylene

Publicidad

loading