Publicidad
Step 4
Separate the EXTENSION SLIDES (HH) from the EXTENSION RAILS (GG) as shown in
å
the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (GG) to the RIGHT END (A) and SMALL UPRIGHT (F).
å
Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
å
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END/SMALL UPRIGHT. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES (HH) will be used later for the DRAWERS.
å
HH
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
TWIST-LOCK®
FASTENERS
Open end
www.sauder.com/services
F
GG
GG
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
GG
A
420410
3S
Open end
NOTE: The end of this
EXTENSION RAIL will
set in from the edge
of the RIGHT END.
Page 9
Publicidad
