Tripp-Lite SmartRack ACAD7761 Manual Del Propietário página 6

Idiomas disponibles

Enclosure Installation

Leveling

WARNING: Level the enclosure before attempting to install equipment. The casters are not designed to provide long-term support for the

enclosure. Use the levelers to provide long-term support. Install the enclosure in a structurally sound area with a level floor that is able to

bear the weight of the enclosure, all equipment that will be installed in the enclosure and any other enclosures and/or equipment that will be

installed nearby.

After the enclosure has been moved to the installation location, use a carpenter's level to check

the slope of the floor. If the floor slopes more than 1%, choose an alternate installation site.

Use an 18 mm open-end wrench to lower each leveler

levelers, 2 at the front and 2 at the rear.) Make sure each leveler contacts the floor solidly.

Note: Lower a leveler by turning it clockwise; raise a leveler by turning it counter-clockwise.

After lowering each leveler, use the carpenter's level to confirm that the enclosure is level in all

directions. Adjust the levelers as required until the enclosure is level.

In order to secure the cabinet to the building structure for stability, attach the 2 shipping brackets

using the hardware that attached the enclosure to the shipping pallet. Use a 13 mm open-end

wrench to connect the brackets to the outer

enclosure. Attach the brackets to secure mounting points in the floor using user-supplied hardware

or Tripp Lite's SmartRack Bolt-Down Kit (Model: SRBOLTDOWN).

Ground Connection

All the parts of the enclosure are grounded to the frame of the enclosure. Use the enclosure's front or

rear threaded grounding point

directly to your facility's earth ground connection with an 8 AWG (3.264 mm) wire. Route the ground

wire under the enclosure's frame to ensure unhindered door operation. WARNING: Attach each

enclosure to earth ground separately. Do not use the enclosure without an earth ground

connection.

20-08-129-932723RevH.indb 6

until it reaches the floor. (There are 4

or inner

bracket mounting points of the

and an M6 screw (included) to connect the frame of the enclosure

FLOOR

EARTH

GROUND

8/24/2020 3:54:08 PM