Publicidad
Idiomas disponibles
Idiomas disponibles
R223
ABOUT THIS MANUAL
During assembly, installation and test operations of the automatic device, hazardous situations might arise if the safety
warnings contained in the instructions are not followed. Carefully read this instruction manual before proceeding.
Instructions must be available with the system for any use or maintenance operation needed.
The data indicated are to be considered for indicative purposes only. The manufacturer is not to be held responsible for
any inaccuracy contained in this manual arising from printing or transcription mistakes.
The company reserves the right to make changes to improve the product without giving prior notice.
GENERAL SAFETY PRECAUTIONS
Carefully read the instructions before starting to install the product.
Packaging materials (plastic, polystyrene, etc.) must not be dispersed in the environment and
must not be left where children can reach them as they are a potential source of danger. Wrong installation of the
equipment can cause serious danger. Please, follow all installation instructions carefully. We recommend operating in a
well-lit and healthy environment, in compliance with the safety regulations in force. We recommend the use of approved
protective clothing (safety shoes, protective goggles, gloves and helmet). Do not wear articles of clothing that could get
caught. Take adequate safety measures to prevent the risk of injury caused by sharp splinters and the possible risks of
crushing, knocks and cuts and amputation collision and shearing danger. We recommend strict observation of the
national regulations for safety in work sites. Delimit the yard to prevent any unauthorised persons from transiting in the
working area. Do not leave the working area unattended. Installation, electrical connections and adjustments must be
carried out in a professional manner in compliance with the good manufacturing and workmanship regulations in force in
the country where the automation is installed. The manufacturer of the device is not responsible for the non-observance
of professional standards of work in the construction of the power-driven structure, nor for any damage which may be
caused by the use of the drive.
Incorrect installation may be dangerous. Follow the manufacturer's instructions.
Before starting installation, check that the product is intact and that the existing structure is suitably strong and stable
and that it is complying with the sector current regulations.
Only suitably skilled technicians trained on the product are
authorised to connect up, test and put into service this product.
We strongly recommend following a specialised training course. Installers should contact the supplier for information on
courses.
Only use the product for the permitted uses specified. Do not use the product for
purposes other than those specified. You should note the operating restrictions specified in the installation
manual supplied with the operator. Do not tamper with or modify the product. The product must only be
installed using APRIMATIC material.
Aprimatic srl declines all liability for damages caused by failure to follow these instructions.
The device can be used by children aged under 8 years and persons with reduced physical, sensory or mental
capabilities, or lack of experience or the necessary knowledge, provided under surveillance or after their having received
instructions to 'ensure safe operation and to the understanding of the dangers inherent in it. Children should be
supervised to ensure that they do not play with the device, including the remote control. Cleaning and
maintenance meant to be performed by the user does not have to be made by children without supervision.
The power supply system must be carried out by a qualified and expert electrician according to
the local requirements, in compliance with local system safety regulations.
Before connecting the power supply make sure that the plate data correspond to those of the electric power distribution
grid. The protection measures on the primary are used on site / in operation.
As main switch of the power supply, use a magnetothermal differential switch of 6A tripping at 30mA cathegory III.
Disconnect the power supply before carrying out any other maintenance operation, repair or replacement, both
mechanical and electrical.
Test and commissioning of the automatic device are not allowed until the sliding automatic gate has not been verified as
complying with the requirements that the finished, assembled and installed gate is subject to.
The installer must check that the temperature range indicated on the label is compatible with the installation site
10
Publicidad
