QSC DPA4.2 Manual Del Usuario página 20

Step 1 — Load Speaker About
ABOUT
This function will load a speaker from the
database to this output channel; it loads
all of the speaker tuning parameters into the
outprocessing.
Step 2 — Load an Existing Loudspeaker for the Selected Output
ABOUT
Speaker:
Band:
Filter:
EN
Crossover
HOME > OUTPUTS > SPKR PROC > CROSSOVER > HIGH-PASS (or LOW-PASS) (ENTER)
NOTE!: If you select a QSC Loudspeaker, you will see that the high-pass, or low-pass filters are LOCKED. QSC has given these
loudspeakers specific voicings tailored for that loudspeaker that should not be changed. If there is any crossover adjustments applied in
these voicings, you will be able to see the applied crossover on the graphs of the Crossover screens.
Step 1 — Set the Crossover High- and/or Low-pass filters
F1: A B C D
HPF
TD-000434-00-B
SPEAKERS LOAD
NEXT
SPEAKERS LOAD
Output: A
QSC AP-5152
Fullrange
Default
LOAD
Output
20 dB
-60 dB
Freq Type Slope
70.0 BWrth 24dB/oct
This function will load a speaker from the
database to this output channel; it loads all
of the speaker tuning parameters into the
out-processing.
Band and Filter selections
are displayed and
constrained based on the
loudspeaker.
To Load the speaker profile to the selected output, press
Freq: 20 - 20 kHz
A
Type:
• Butterworth
• Linkwitz-Riley,
• Bessel-Thomson
Slope:
6dB to 48dB/oct depending
on Type
20
To continue, press
To edit Speaker, press
Scroll to select Speaker model
To confirm, press
Scroll to (Band, Filter)
To adjust, press
Adjust selected parameter
To confirm, press
Scroll to LOAD
Scroll to select (Freq, Type, Slope)
To edit, press
Turn to adjust parameter
To confirm, press
To exit, press
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
EXIT