cecotec BOLERO DRESSCODE 7500 INVERTER A Manual De Instrucciones página 38

ENGLISH
4. Pour hot water into the drum and leave it for about 10 minutes.
5. Reconnect the water inlet hose to the tap.
Please note
1. When resuming use of the washing machine, make sure that the ambient temperature is
above 0°C.
2. If the washing machine is located in a room where it can easily freeze, thoroughly drain
the remaining water inside the drain hose and water inlet hose.
3. Refer to a technician if the washing machine freezes. If the washing machine still does
not work after the above procedure, please contact the official Cecotec Technical Support
Service.
6. TROUBLESHOOTING
PROBLEMS POSSIBLE SOLUTIONS
There's water in the drum This is normal. It's the result of factory water tests.
before first use.
The washing machine does Check that the plug is properly connected to the socket.
not turn on. Check if the tap is open.
Check if the Power button was pressed.
Check if the Start/Pause button was pressed.
Check if the Delay Start function is enabled.
The washing machine leaks. Check and tighten the water inlet hose.
Clean the drain hose and contact the official Cecotec
Technical Support Service.
Strange noise and strong Check whether the transport bolts have been removed.
vibrations. Check if the levelling feet are properly adjusted. Check if the
washing machine is installed on a level and solid surface.
Check for metal items inside.
Washing results are not Select a suitable washing programme.
satisfactory. Add the appropriate amount of detergent according to the
instructions on the detergent package.
The buttons do not work. Check whether the "Child Lock" function is enabled.
B O LE R O D RESSCO DE 75 00 INV ERTE R A
74
The actual running time Check if the laundry in the drum is evenly spread out.
of the programmes does Check if the water flows in and out properly.
not correspond to the time
indicated on the display.
The washing machine fills up Check if the height of the drain hose is less than 65 cm.
during draining. Check if the drain hose is submerged.
7. ERROR CODES
CODE PROBLEM POSSIBLE SOLUTIONS
E1 The washing Check if the water inlet tap is open.
machine takes Check that the water pressure is not too low.
a long time to Check that the water inlet hose is not dirty or blocked.
fill up.
E2 The washing Check that the drain pump is not blocked.
machine takes a
long time to drain
the water.
E3 The door is not Check that there are no items such as clothes or dirt between
closed properly. the door and the seal.
E4 The water Check that the water outlet hose is not dirty or blocked.
overflows.
E5 Electric motor Contact the Technical Support Service of Cecotec.
failure.
E6 Heating element Contact the Technical Support Service of Cecotec.
failure.
E7 Temperature Contact the Technical Support Service of Cecotec.
sensor failure.
E8 PCB or frequency Contact the Technical Support Service of Cecotec.
inverter board
failure.
BOLERO DRES SCODE 7500 IN VERTER A
ENGLISH
75