Jocel JP4EI002099 Manual De Instrucciones página 67

If an abnormality comes up, the induction hob will enter the protective state automatically and
display corresponding protective codes:
Problem
No pot or pot not suitable
E2/E3 Abnormal supply voltage
Temperature sensor of
E4/E5
the IGBT failure
Temperature sensor
E7/E8
failure
Bad induction hob heat
E6/E9
radiation
PCBA communication
Eb/EC
failure
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction
hob.
Possible cause What to do
Replace the pot
Please inspect whether power supply is normal.
Power on after the power supply is normal.
Please contact the supplier.
Please contact the supplier.
Please restart after the induction hob cools down.
Please contact the supplier.
67