Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVAL
Install the special tool on the cylinder head.
Hand tighten screws along the arrows.
Attention!
Don't support yourself on the plate of the
removal tool! Impermissible lateral forces
can thereby develop on the injectors!
Screw in completely the removal thread (3).
Removal thread is a left-hand thread.
Insert screw collars (4) and screw them on the
receptacles for
injectors.
Then tighten the screws along the arrows to 5
Nm.
Set torque wrench (B) to 13 Nm releasing to
right.
Turn torque wrench clockwise until the injector
is removed.
Remove all injectors individually.
Attention!
If the torque wrench disconnects when
removing the injector, the
injector must be replaced.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
