IPC Diesel-C L DL2017P Manual De Instrucciones página 24

CLOTHING AND EQUIPMENT
Wear safety shoes with non-slip soles.
Wear protective goggles or visor and safety
garments.
You are recommended to wear overalls to reduce the risk of
injury caused by involuntary contact with the high pressure jet.
USING
THE CLEANER
STARTING THE CLEANER
Turn on the water supply tap
(fig. 5A).
1) Place the petrol tap lever in
the open ON position (fig. 7).
2) Turn the ignition key to pos.
I, and then to Start. Release
the key as soon as the engine
starts. The key will return to
pos. I.
!
Warning
If the engine does not start:
- Wait until the engine stops
turning completely before
attempting to restart:
activating the starter motor
while the engine is still turning
may damage the starter motor
and flywheel.
- Wait at least 30 seconds be-
fore attempting to restart the
engine: this allows the battery
to recover voltage, avoiding
damage to the starter motor
due to low battery voltage.
The engine can also be started
using the zip pull starter. For
details on the procedure, re-
fer to the engine's instruction
booklet. (fig. 9).
!
Warning
- If there is not enough oil or
none at all, the engine does
not start.
- The high pressure water jet
generates a reaction force in
the lance. Keep a firm grip on
the lance handle.
English
Press the trigger on the gun
and begin washing.
! Danger
Do not block the handle lever
in the delivery position.
IMPORTANT.
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfun-
ction (fig.10).
STOPPING THE CLEANER
1) After using with detergent,
flush out the intake circuit;
place the detergent suction
hose (fig. 11) in a tank of clean
water and let the pump run for
1 minute with the dosing tap
turned fully on and the lance in
detergent delivery condition.
2) Stop the cleaner.
FIG. 7
a) Posizionare la chiave di
avviamento in posizione 0.
(fig. 8).
b) Place the fuel pump lever
in the closed OFF position
(fig. 7).
3) Discharge the pressure
from the H.P. hose by pressing
the trigger on the gun.
4) Turn off the water supply
tap (fig. 5A).
FIG. 8
! Warning
- If the water cleaner is left, even temporarily, turn it off.
- When the water cleaner is not used, close the safety device
on the handle (fig. 12).
- Dry use of the water cleaner causes serious damage to pump
gaskets.
FIG. 9
- 20 -
FIG. 10
FIG. 11
FIG. 12