Publicidad
Idiomas disponibles
Idiomas disponibles
This Li-ion machine has a "soft-start" feature.
When you start the machine, it goes to full speed after
approximately 3 seconds.
NOTE
If the machine does not start, remove the battery pack
and examine the mower deck to make sure that:
•
no grass catches on the blade.
•
the blade can turn freely by hand.
7.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
WARNING
Always remove the battery pack after you complete
the work.
7.3
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the battery pack.
3. Open the rear discharge door and hold it.
4. Hold the grass catcher by its handle and unhook it
from the slots.
5. Close the rear discharge door.
6. Empty the grass catcher.
7.4
OPERATE ON SLOPES
WARNING
Do not mow on the slopes with incline more than 15°.
If you are not comfortable, do not mow on a slope.
•
Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
•
Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
•
Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
•
Do not mow near drop-offs, ditches, or
embankments.
7.5
OPERATION TIPS
•
Do not try to override the operation of the start
button or bail switch.
•
Do not tilt the machine when you start it.
English
•
Do not put hands or feet near or below the turning
parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick
grass.
•
Clean the bottom of the mower deck after each
use. Remove grass clippings, leaves, dirt, and other
debris.
8
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Keep the motor and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
8.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use
water.
11
WARNING
WARNING
CAUTION
CAUTION
CAUTION
EN
Publicidad
