Descargar Imprimir esta página

GreenWorks 2540802 Manual Del Operador página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
8.2
REPLACE THE BLADE
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw and spacers with a
wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised
points engage the holes in the blade.
9. Put in the mounting screw and spacers and tighten
them.
8.3
STORE THE MACHINE
Clean the machine before storage.
Make sure the motor is not hot when you store the
machine.
Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person at an approved service
center.
Store the machine in a dry area.
WARNING
WARNING
English
Make sure that children cannot come near the
machine.
9
TROUBLESHOOTING
Problem
The handle is
not in position.
The machine
does not start.
The machine
cuts grass un-
evenly.
The machine
does not mulch
correctly.
The machine is
hard to push.
There is a high
vibration in the
machine.
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correct-
of the handle
ly.
and make sure
that the knobs
and bolts are
aligned correctly.
The battery ca-
Charge the bat-
pacity is low.
tery pack.
The bail switch is
Replace the bail
defective.
switch.
The lawn is
Examine the
rough.
mowing area.
The blade height
Move the wheels
is not set cor-
to a higher posi-
rectly.
tion.
Wet grass clip-
Wait until the
pings attach to
grass dries be-
the deck.
fore mowing.
The mulch plug
Install the mulch
is missing.
plug.
The grass is too
Increase the
tall, or the blade
blade height.
height is too low.
The grass catch-
Empty the grass
er and the blade
clippings from
drags in thick
the grass catch-
grass.
er.
The blade is un-
Replace the
balanced and
blade.
worn.
The engine shaft
1. Stop the en-
is bent.
gine.
2. Remove the
battery pack.
3. Disconnect
the power
source.
4. Inspect for
damage.
5. Repair the
machine be-
fore you start
it again.

Publicidad

loading