Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
a
2.
Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards at the same time until it is
released from its seating. Put the door to one side,
resting it on a soft surface.
~15°
a
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
TROUBLESHOOTING
Problem
The oven is not working.
The door will not open.
The display shows the letter "F"
followed by a number.
b
b
Possible cause
Power cut.
Disconnection from the
mains.
Fault with the door lock.
Cleaning cycle in progress.
Software problem.
4.
Lower the door and then open it fully.
Lower the catches into their original position: Make
sure that you lower them down completely.
a
Apply gentle pressure to check that the catches are in
the correct position.
"CLICK"
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above: The door could become damaged if
it does not work properly.
WWW
www.aristonchannel.com for more information
Solution
Check for the presence of mains electrical power
and whether the oven is connected to the
electricity supply.
Turn off the oven and restart it to see if the fault
persists.
Switch the oven off and on again to see if the
fault persists. Wait for the function to finish and
for the oven to cool down.
Contact you nearest Client After-sales Service
Centre and state the number following the letter
"F".
b
Download the Use and Care Guide from
Publicidad
