JUKI TL-15 Manual De Instrucciones página 15

Winding the bobbin
❶
❷
Concave portion
Convex portion
2
Take out the bobbin from the bobbin
case.
Snap in the latch to let the bobbin come out of the
bobbin case.
3
Thread the bobbin winder guide.
If the thread slips out of the bobbin winder guide,
pass it through the hole located under the bobbin
winder guide.
4
Installing the bobbin.
❶ Pass the thread through the hole of the bobbin.
❷ Adjust the convex portion of the bobbin thread
winding shaft to the concave portion of the
bobbin to set the bobbin.
❸
❸ Press the bobbin presser.
5
Start winding the bobbin.
6
Upon completion of winding the bobbin.
Return the bobbin presser on your side. Trim the
excessive thread and take out the bobbin.
13