La Pavoni LPSCCC01EU Manual De Uso página 29

6. CLEANING AND MAINTENANCE
6–1. CLEANING THE STEAM AND HOT
WATER NOZZLES
• To avoid altering the taste of the
drinks to be heated and to prevent the
holes at the end of the nozzles from
becoming clogged, clean thoroughly
with a damp cloth after each use and
dispense a small amount of steam.
6–2. CLEANING THE GROUP HEAD AND
SHOWER SCREENS
• Remove the filter holder from the
group head and clean the group's
gasket using the brush (16) provided.
• Place the blind filter (24) provided in
the filter holder (22-23).
• Add a spoonful of coffee machine
cleaning powder and insert the filter
holder into the group head.
• Use the group head control (15) to
start dispensing and stop delivery after
approximately 15-20 seconds.
• Start and stop delivery several times
until clean water is dispensed, in
order to remove coffee and limescale
deposits.
• Remove the blind filter (24) and start
dispensing several times in order to
rinse the group head and eliminate
any residues from the shower screens
and the group head.
If hot water has remained in
the pipes for a long time, we
recommend that you allow
water to flow out to remove any
deposits.
6–3. CLEANING THE FILTERS AND
FILTER HOLDERS
• Regularly check the holes in the filters
in order to remove any coffee deposits.
• Place approximately one litre of boiling
water and four teaspoons of coffee
machine cleaner in a suitable container.
Immerse the filters and filter holders
in the solution for 20-30 minutes. Then
rinse thoroughly under running water.
6–4. CLEANING THE LOWER DRIP TRAY
Remove the drip tray grid (8) and the drip
tray (13). Remove any coffee residues
from it by rinsing it under running water.
6–5. CLEANING THE OUTSIDE OF THE
MACHINE
To keep the outer surface of the coffee
machine in good condition, it should
be cleaned regularly after use. Let the
appliance cool down first. Clean with a
soft, damp cloth.
6–6. REPLACING THE GROUP HEAD
GASKET (Fig. 7)
• If coffee leaks from around the edges of
the filter holder (L) when it is dispensed,
it may be due to an obstruction in the
delivery hole of the filter-holder, in
which case the hole should be cleaned.
• If the problem persists or if the filter
holder moves significantly beyond
the centre of the group head when it
is being fitted, the group head gasket
should be replaced.
To replace it, proceed as follows:
• Make sure that the machine is switched
off and disconnect the power cable.
• Remove the gasket (I) and the shower
screen (M), using a flat screwdriver as
a lever.
• After having removed the gasket and
shower screen, clean the seat properly
before installing the new components.
• Once the new components have
been installed, insert the filter holder,
without the filter, into the group head
and move it in order to seat the gasket.
25