Publicidad
Idiomas disponibles
Idiomas disponibles
• The heater must be disconnected during installation and cleaning.
• Never rotate the heating part of the appliance during operation. To change the tit angle of the heating part,
we advise you to wait for 15 minutes after the appliance has been switched off.
• Never dismantle the components of the heater or replace the components with the ones that do not meet
the safety requirements.
WARNING: The surface of this heater can be hot. Parts of the heater may exceed 200ºC.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention must be
given when children and vulnerable people are present.
WARNING: IN ORDER TO AVOID OVERHEATING, DO NOT COVER THE HEATER.
2. INSTALLATION WARNINGS
Warning. Fragile Glass Lamp. Use care when unpacking, handling and installing.
WALL MOUNTED
Medium wave Infrared heat is featured by a strong central beam that dissipates heat to a gentle intensity
heated area outside the central beam.
The zone heated by IFC-2000 will increase in size the higher the heater is installed from the floor, but the
warmth experienced from the heater will be lower.
The installed height and the intensity should reflect the intended use of the heater.
-
Install the heater at a lower height in areas where more intense warmth is required.
-
Install IFC-2000 higher where less intense warmth is required.
For permanent installation, the unit must be located in a position to allow proper an efficient use but
ensuring hot parts cannot be touched accidentally.
The recommended installation height of the is 2.4m to 3.5m from the floor.
Important: Do not install the heater below 2.4m if any kind of automated on/off controller is going to be
used.
Ceiling Mounted
Wall Mounted
CEILING MOUNTED
A(m)
B(m)
H(m)
3.0
6.0
3.0
6.0
9
2.4
2.4
Publicidad
