Publicidad
Idiomas disponibles
Idiomas disponibles
4.- OPERATION
REMOTE CONTROLLER OPERATION
Infrared IFC-2000 is operated using the remote control supplied with the heater. Insert 2 x AAA Alkaline
batteries into the remote control.
Note: All IFC2000 units and their remote controls have the same frequency, so it is possible to control several
IF2000 units with just one remote control.
Timer Adjustment
Press Timer button (5) and use the Up and Down buttons (2) and (3) to select the number of hours the heater
will be working. The heater will be working providing the selected heat level during these hours. When the time
has finished, the heater will automatically disconnect the heating elements.
Inserting Batteries
Insert 2 AAA/ Alkaline type batteries into your remote control
1. Flip the backside of your remote control and pull out battery cover. Insert the batteries in accordance with
the instructions and polarity of the batteries.
2. Change the batteries in the same way described above.
Warning:
1. Replace the old batteries with the same type batteries. Otherwise, your heater may not function well.
2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your remote
control.
3. Do not allow water or liquid to get into the remote control.
5.- TROUBLESHOOTING
E1 Error on display
E2 Error on display
No heat when L1,2,3
o 4 shown on display
Button
Function (Heater On)
1
Turn the heater off
2
Increase Heat Level or
3
Decrease Heat Level or
4
Enable Heat Level
5
Enable Timer adjustment
Control Unit Overheat. Check installation clearances. Let heater cool for 15 minutes
and restart heater.
Tip over function. Make the heater working less than 60º angle and restart the heater.
Bulb is damaged. Contact Technical Service.
Remote Control Function
Function (Heater Off) LED Display on
Timer hours
Timer Hours
adjustment
13
Turn the heater on
Turns heater on to
Level 4 (maximum)
Turns heater on to
Level 1 (minimum)
Heater
L4
L1
L [n]
[0H]-[24H]
Publicidad
