Rear Panel - Tascam CD-400U Manual Del Usuario

Rear panel

ANTENNA FM connector
z
Connect the included FM antenna here.
Extend the antenna and attach it to a window frame, wall or
other surface where it provides the best reception.
ANTENNA AM connector
x
Assemble the included AM loop antenna and connect it to
the AM antenna connector on the back of the unit.
Place the antenna in the position where it provides the best
AM broadcast reception.
TUNER OUT jacks
c
These analog RCA pin output jacks always output the sound
from the tuner.
The nominal output level is -10 dBV.
RS-232C connector
v
This is a 9-pin D-sub RS-232C control input/output connector.
Connect a computer, for example, here. (see "Using the RS-
232C connector" on page 38)
Option slot
b
This slot is for installation of an Ethernet card (sold separate-
ly).
ANALOG OUT (UNBALANCED) L/R jacks
n
These are analog RCA pin output jacks.
The default nominal output level is –10 dBV (OFF analog
output level setting), but it can also be lowered in 1dB incre-
ments to −28 dBV (-18dB analog output level setting). (see
"Adjusting the analog output" on page 38)
ANALOG OUT (BALANCED) L/R jacks
m
These are balanced XLR analog output jacks.
The default nominal output level is +4 dBu (OFF analog
output level setting), but it can also be lowered in 1dB in-
crements to –14 dBu (-18dB analog output level setting). (1:
GND, 2: HOT, 3: COLD) (see "Adjusting the analog output" on
page 38)
AC IN connector
,
Connect the included power cord here.
2 – Names and Functions of Parts
15
TASCAM CD-400U