Braun IS7286BK Manual Del Usuario página 15

Before first use
When steam is ready for the first time we
recommend to iron for a few minutes over
a rag to avoid manufacturing residues can
dirty your garments.
(A) Filling the water tank
Make sure that the appliance is switched off
and the system is unplugged.
Remove the water tank (9).
z
Fill the water tank with tap water, taking
z
care not to exceed the "max" level but at
least up to the mark "min".
If you have extremely hard water, we
z
recommend that you use a mixture of 50
% tap water and 50 % distilled water.
Never use distilled water exclusively. Do
z
not add any additives (e.g. starch). Do not
use condensation water from a tumble
dryer.
Insert the water tank.
z
Place the appliance on a stable, level
z
surface.
Note: If you use filtering devices or in-house
permanent descaler, make absolutely sure
the water obtained is neutral ph.
(B) Water reserve function
When the water level is becoming low, the
water reserve icon
this stage it is possible to continue steam
ironing for about 10-15 minutes.
When the water
permanently on, it becomes necessary to
refill the water tank. At the same time, the
On/Off icon (1) and the icon related to the
selected setting start flashing.
To continue steam ironing, refill the water
tank at least up to the mark "min".
(C) Start into operation
Before start ironing follow the garment care
label instructions carefully. Fabrics with this
symbol are not ironable.
14
(4) starts flashing. At
reserve icon turns
Place the iron on the iron rest (7) or on
z
its heel rest (13), unwind completely both
cords (11,12), plug in the appliance and
press the On/Off button (1).
The iCare setting (
z
button start flashing and you hear an
acoustic signal. The iron will start to heat
up.
Once the temperature is reached, the On/
z
Off button and the related steam setting
icon turn permanently on and you hear an
acoustic signal indicating steam is ready.
Steam ironing
Press the steam button (6) to release steam.
Dry ironing
Iron without pressing the steam button (6).
Please note that after 10 minutes of dry
ironing, the iron switches to the stand-by
mode. After additional 10 minutes the auto-
off mode is activated.
Steam shot function
Press the steam button (6) twice in quick
succession within 1 second. There will be
a continuous steam emission for a few
seconds. Press the steam button once again
during steam emission to stop the function.
(D) Settings
When the appliance is switched on, it will
always be set to the iCare
independently on the last setting chosen.
To switch from one setting to another, press
the iMode selector (5a).
Eco
It is suggested for most delicate garments
like synthetics, silk and blended fabrics. This
setting allows less power consumption.
iCare
It is suggested for garments like wool,
polyester and cotton.
Turbo
It is suggested for garments that need more
powerful steam, like thick cotton/linen and
jeans.
) and the On/Off
setting,