Fanimation HENRY FP8519BL Manual Del Usuario página 12

How to Assemble Your Light Kit and Glass (continued)
3. Remove one of the three screws in the light kit
and retain the screw for later. Slightly loosen the
remaining two screws. (Figure 3)
4. Securely attach 9-pin connector from motor
assembly to wiring harness socket within light plate/
LED assembly. (Figure 4)
WARNING
The color label on these two connectors must correspond
to each other.
5. Assemble the light plate/LED assembly to the light
kit using the two key slots and replace the third screw
and securely tighten all three screws. (Figure 5 )
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6. Secure the glass to the light kit by twisting in a
clockwise direction. Do not over-tighten. (Figure 6)
Light Kit
Motor
Assembly
Light Plate/LED
Assembly
Light Kit
Light Plate/LED
Assembly
Glass
12
Figure 3
Figure 4
Figure 5
Light Kit
Figure 6