Virtual Barrier - SOLAC ECOGENIC Instrucciones De Uso

,
If you wish, you can control its movements or functions using the remote control buttons
(please refer to the "REMOTE CONTROL" section), or using the buttons of the control
panel on the robot vacuum's body.
,
Press the UV key, if you want to sterilise the front area.
This function is particularly recommended for people suffering from allergies and for
homes with pets, as it sterilises the floor against viruses and bacteria.
8 Press the
9 If you do not want a programmed weekly clean, turn off the appliance after cleaning.
To do so, set the operating switch (20) to the OFF position or press the ON/OFF button
on the remote control.
10 Unplug the charging station from the mains.

VIRTUAL BARRIER

MAIN COMPONENTS (B)
1B ON switch & Length of virtual
barrier
Off
Short range = 4 m
Medium range = 6 m
Long range = 8 m
OPERATION
,
Use the virtual barrier to define the desired cleaning area, preventing the robot from
entering unnecessary or unwanted areas.
Use this to prevent the robot entering areas with cables or a particular room.
)
Place the virtual barrier at the same level on the surface where you are going to use
the robot vacuum.
)
Place the virtual barrier and the charging station at a distance of more than 3 m apart,
to prevent interferences.
)
Do not place the charging station within range of the virtual barrier's signal.
,
The proximity sensor head (3B) prevents impact between the robot vacuum and the
virtual barrier, preventing it from coming within a distance of less than 0.5-1 m from it.
1 Make sure that the batteries are not discharged.
2 Position the virtual barrier so that it blocks the area you do not want the robot vacuum
to enter. (fig. 3).
3 Remove any objects that may be in front of the virtual barrier, to prevent its inadequate
operation.
4 Choose the desired length of the virtual barrier. To do so, set the switch (B) to choose
short , medium
,
Use the appropriate barrier length. The battery's duration depends on the selected
sensor distance.
,
The LED ON light (2B) will flash every 8 seconds until the battery runs out.
5 Check that the robot vacuum cannot cross the boundary created by the virtual barrier.
6 Set switch (B) to the OFF position
,
Some differences may occur in the direction of the virtual barrier's infrared signal and
the robot's reception range, due to the movement of the robot during while in use. This
difference may vary depending on the work environment and the charging level of the
robot and the virtual barrier.
VIRTUAL BARRIER
button again to pause the cleaning process.
or long range.
2B LED ON light
3B Proximity sensor head
4B Virtual barrier sensor head
5B Battery compartment cover
6B Battery cover clip
, when the virtual barrier is not required.
en
21