Additional Functions; Error Codes - SOLAC ECOGENIC Instrucciones De Uso

4 Press to confirm the selection.
)
Press the ON/OFF button
)
For the robot vacuum to start up at the planned time, it must be switched on. The
operating switch (20) in the ON position and

ADDITIONAL FUNCTIONS

FULL GO Function
)
If this function is selected, the robot vacuum is programmed to continue cleaning once
it is fully charged.
1 Press the
,
FULL GO will light up in the remote control display. The robot vacuum will search for the
charging station before the battery runs out and will automatically start cleaning when
it is fully charged.
SPEED Function
1 Press the
,
FAST will light up in the remote control display.
2 Press the
,
SLOW will light up in the remote control display.

ERROR CODES

If the robot is not functioning properly due to one of the following circumstances, all of the
robot's control panel buttons will flash simultaneously.
1 Press the
within the active range of the appliance.
,
The error icon
described below.
2 Perform the actions described below depending on the error displayed.
E C C
RROR ODE AUSE OF THE
E01 Stair detector sensors
E02 Central roller
E03 Low battery
E04 Side wheels
E05 Dustbin
,
If the failure persists after fulfilling these actions, do not use it and take it to an
authorised assistance service. Do not modify or repair the appliance.
STORAGE AND STORAGE
n
Prior to any cleaning or maintenance operation, ensure that the operating switch
(20) is in the OFF position and that the appliance is not connected to the mains.
)
Make sure that all washed elements are completely dry prior to assembly.
)
Never immerse the vacuum module (15) in water or any other liquid, or place it in the
dishwasher. Do not use abrasive products or solvents.
STORAGE AND STORAGE
if you want to cancel the setting.
button. The robot vacuum must be switched on.
button to choose fast clean.
button to choose slow clean.
button of the remote control. Ensure that the remote control signal is
will appear in the remote control display beside one of the error codes
F S
AILURE
Clean the sensors (27).
Remove any dirt and hair trapped in the roller (23).
Charge the battery.
Remove any dirt and hair trapped in the wheels.
Fit adequately the dustbin (11).
lit.
OLUTION
en
23