Publicidad
1.
Locate studs. Verify the center of the stud(s) using an awl, a thin nail, or an edge to edge stud finder. Level the wall plate template
mark the hole locations in the center of the studs. NOTE: Do not use center 3 slots for steel stud mounting.
NOTE: TV with brackets can be shifted to the left or right from center. Consider this when selecting the location of your wall mount.
2.
Drill pilot holes using a 1/2 in. (13 mm) diameter drill bit then remove the wall plate template
1
16 in. (406 mm)
24 in. (609 mm)
2 4 i n .
( 6 0 9 m
m )
1 6 i n .
( 4 0 6 m
m )
NOTE: For assistance in
determining wall plate location, try our
HeightFinder
™
at SANUS.com/2665
2
18
.
18
1 in. (25 mm)
1/2 in.
(13 mm)
and
18
18
15
Publicidad
