Klauke MAP 1 Manual De Instrucciones página 34

Instruction Manual MAP 1
_______________________________________________________________________________________________________________________
In order to safeguard a safe and proper performance of the charging unit the repair and service
of the unit should be made through our Authorised Service Centers (ASC's).
5.6. Storage and transport
In order to protect the tool against damages it has to be cleaned carefully after every use and be
put into the transportation case which has to be closed safely. Into this plastic carrying case you
accommodate besides the pressing tool the charging unit, 4 jaws, 3+1 interchangeable dies and
the instruction manual (see picture 8+11).
6. Troubleshooting
a.) Constant flashing of the light diode display (Pos.-#. 9) at the end of a pressing cycle.
=> Service due. Please send the tool to your nearst Authorized Service Center (ASC).
(Pls. see also chapter 4.3 for more information)
b.) The tool loses oil.
=> Return the tool to the manufacturer. Do not open it and damage the seals of the tool.
c.) The pressing tool does not reach the final operating pressure.
=> Stop the crimping process. Actuate the retract slide (Pos.-No. 2) and the operating
switch continuously and simultaneously for about 10 sec. Is the malfunction not be
eliminated by this attempt the tool has to be returned to the manufacturer.
page 34