Publicidad
Idiomas disponibles
Idiomas disponibles
5. START
Once installation has been completed, check the continuity of the earth circuit and
carry out all the electrical safety tests provided for by current regulations. Protect and
adequately block the cables to avoid any risk of accidentally pulling the cable which
could disconnect it or which could cause it to come into contact with a hot part of this
appliance (or another one) at a temperature over 50°C or with a sharp part. If the power
cable is damaged, it must be replaced by the manufacturer or by the manufacturer's
technical service centre or, in any case, by a person similarly qualified, in such a way as
to prevent any risk.
•
Make sure that all the packaging materials have been removed.
•
Test all piping to make sure that there are no leaks.
•
Check all the electrical connections.
Motor protection time. The appliance is equipped with a motor protection control which
starts the compressor only after 1 minutes from the last power on. This also happens after
any interruption in the electrical supply, whether voluntary or involuntary (a blackout).
Switching on/Turning off
To turn the air conditioner on/off, press and hold the ON/OFF key for 2 seconds.
Operating modes
The unit is able to operate in 3 distinct modes by selecting them from the control panel
with the 3 key. To set the various modes, press the MODE key and refer to the following
table:
The system works autonomously, adjusting the speed of the compressor and fans to
ensure maximum performance.
AUTO
Press the MODE key repeatedly until the symbol AUTO
The system works autonomously, adjusting the parameters in order to ensure
maximum duration of operation. The electronic board regulates the fan and
ECO
compressor speeds to minimise consumption and to increase autonomy.
Press the MODE key repeatedly until the symbol ECO
The system works autonomously, adjusting the parameters in order to ensure
maximum operating silence. The electronic board regulates the speed of the fans
NIGHT
and the compressor to minimise noise inside the cab.
Press the MODE key repeatedly until the symbol NIGHT
In all the listed modes the fan speed is automatic, however it is possible to change
the speed at any time according to your needs by pressing the 2 key.
AUTO
ECO
NIGHT
ENG
27
Publicidad
