Publicidad
Idiomas disponibles
Idiomas disponibles
NT1865DM(S)
NT1865DMA(S)
(NN)
OPTIONAL ACCESSORIES
sold separately
○ BATTERY (BSL1830C/BSL1820M)
NOTE
Accessories are subject to change without any
obligation on the part of metabo HPT.
APPLICATIONS
<NT1865DMA(S), NT1865DM(S)>
○ Nailing as fi nishing process for areas around the
doors, windows as well as edgings.
○ Securing the bottom of drawers. Making various
cases and cabinets.
REMOVAL AND INSTALLATION
METHOD OF BATTERY
CAUTION
● Be sure keep the fi ngers away from the trigger
and push lever away from the wood.
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery.
Latch
Push
Safety glasses ....................................................................................... 1
Nose cap (mounted on tool) .................................................................. 1
Handle
Battery
Pull out
Insert
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on
the nameplate, the charger will burn up.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
the fi gure.
Pilot lamp
Charger
English
WARNING
Battery
15
Publicidad
