Samson EXPEDITION XP208w Manual Del Propietário página 8

HXD1 Wireless Microphone Controls
1. Status Indicator - This LED displays the
operation mode:
Amber: Normal Operation
Flashing Amber: Pairing / Low Battery
2. Power/Pair Switch - Press less than 5 seconds
to turn the unit on or off. Press more than 5
seconds to enter pairing mode.
3. Battery Cover - Unscrew the battery cover
and slide down to open the HXD1 battery
compartment.
4. Battery Holder - Open the battery holder by
pressing the tab and lifting the cover. Insert
two standard AA (LR6) batteries here, being
sure to observe the plus and minus polarity
markings shown.
WARNING: Do not insert the batteries
backwards; doing so can cause severe damage
to the HXD1 and will void your warranty.
5. Input GAIN Control - This control adjusts the
transmitter input sensitivity.
6. Screwdriver - Used to adjust the input GAIN
control.
RXD2 Receiver Controls
1. USB Connector - Plugs into the USB jack on
the rear panel of a wirelessly enabled Samson
audio device. The receiver can also plug
directly into a computer USB port and will
be recognized as a USB audio device. The
unit passes audio to the device and receives
power from the device through this connector.
If connecting the LINE output to an analog
device, the RXD2 can be powered using a
standard 5 Volt adapter.
2. PAIR Switch - Press >5 seconds to enter
pairing mode.
3. STATUS Indicator - This LED displays the
operation mode:
Amber - Normal Operation
Flashing Amber - Pairing
No Light - Not paired; Transmitter out of range;
No Power
4. LINE / Headphone Output - Use this 3.5mm jack
when connecting to an analog line input or
headphones for monitoring.
8
1
2
5
6
3
4
4
3
2
1